Configuration Options For Thconfig Command - Brocade Communications Systems 8 Administrator's Manual

Configuration options for thConfig command

Use the thConfig command to configure thresholds for Fabric Watch event monitoring for the SFP,
Fabric, Security, and Performance classes or to display the configuration. If configured areas
exceed the currently-effective threshold settings, the Fabric Watch daemon can take one of the
following actions:
•
•
•
•
Setting guidelines and default settings for the Fabric, Security, SFP, and Performance classes are
detailed later in this chapter.
For additional information about the ThConfig command, refer to the Fabric OS Command
Reference Manual.
TABLE 12
Class name
SFP
Fabric
Security
Filter
Fabric Watch Administrator's Guide
53-1001770-01
Send an SNMP message.
Log a RASlog message.
Send an e-mail alert.
Log a port log message.

Configuration options for thConfig command

Valid area types
TXP - Transmit areas
RXP - Receive areas
Current
Voltage
Temperature
ST - SFP state changes
ED - Number of E_Ports
down
FC - Fabric reconfiguration
DC - Domain ID changes
SC - Segmentation changes
ZC - Zone changes
FL - Fabric logins
TV - Telnet violations
HV - HTTP violations
SV - Serial violations
DV - DCC violations
IC - Invalid certifications
LV - Login violations
TS - TS out-of-sync
FF - SLAP failures
NF - No FCS
ISB - Incompatible security
IV - Illegal command
CUSTDEF
Configuration options for thConfig command
Threshold Threshold Configuration recommendation
action
Default or Default or Use the SFP default settings. The
1 2
Custom Custom traits are SFP-specific and there is no
reason to alter them. See
monitoring setting guidelines"
page 47 for more information.
Default or Default or It is recommended that you leave the
1 2
Custom Custom entire Fabric class in its default state
(no alerts).
See
guidelines"
information.
Default or Default or Use the Security class default settings
1 2
Custom Custom for areas and alarm configuration.
There is no reason to alter the default
settings.
Default or Default or Use the Filter default settings.
1 2
Custom Custom
6
"SFP
on
"Fabric monitoring setting
on page 42 for more
51