Specifying Alarm Input <Alarm In - Sanyo VCC-P9574S - 1/4" CCD Pan-Focus PTZ Dome Camera Instruction Manual

Specifying Alarm Input <ALARM IN>
1
Set <ALARM IN> to the input channel (1 or 2) and
press the SET button.
·ALARM IN
ALARM OUT
MOTION
uAREA
uSENSITIVITY
ZOOM
·ALARM IN
uZOOM TIME
DURATION
ALARM SIGN
PRESET
MENU
2
Select <POLARITY> and specify a polarity for the
signal.
·POLARITY
NO : Normal Open (When closed, detects an alarm input.)
NC : Normal Close (When opened, detects an alarm input.)
ALARM SETTING
SET
1 y
NO
R
OFF
SET y
SET y
OFF
5S
5S
OFF
OFF
BACK
ALARM IN SETTING
·POLARITY NO
MOVE OFF
ALARM OUT OFF
3
Select <MOVE> and set the camera to move to
the preset position of the channel where the
alarm has been detected.
The camera will move to "PRESET NO.1" position if an alarm is
detected by ALARM IN1 and to "PRESET NO.2" position when the
alarm is detected by ALARM IN2.
·MOVE
ON : The camera moves to "PRESET No.1 or 2" position and stops.
: The camera moves to "PRESET No.1 or 2" position, remains there
AUTO
for the time set in <DURATION> (see page 40), then returns to the
original monitoring mode.
OFF
: The camera remains where it is.
Note: • Be sure to have a preset position registered for "PRESET NO.2"
before setting ALARM IN2. The MOVE function will not operate if
not registered.
• If <MOVE> is set, zooming (see page 40) will not take place even
at alarm detection.
• If an alarm is detected even if motion is simultaneously detected,
<MOVE> takes priority.
• If an alarm is detected by another input channel when <MOVE> is
operating, the camera moves to the preset position of that
channel, and <MOVE> becomes operative in that position for the
time set in <DURATION>.
Setting Alarm <ALARM>
ALARM IN SETTING
POLARITY NO
·MOVE OFF
ALARM OUT OFF
36