Accelerator Cable - GAS GAS PAMPERA 450 - 2007 Manual

- Clean the filter in a
bath filled with filter
cleaning fluid using a
soft brush.
- Check the air filter for damage such as scraping, hardening, shrinkage...
If it is damaged, replace it. Otherwise, dirt will enter the engine.
- Grease all of the connections and bolts of the air filter and inlets.
- Fit the air filter to the motorcycle and ensure that it is correctly
connected.
- Squeeze it and take it
out with a clean cloth.
Do not touch or air the
filter again, as this may
damage it.
- Fit the filter in the cage
and cover the filter lip
(A) with a thick layer of
grease to ensure a good
seal and to prevent dirt
from entering.
24
- -
THROTTLE CABLE
- Check that the throttle grip turns smoothly
- Check that the throttle grip has 2-3 mm of play.
- If the play is incorrect, loosen the locknut on the upper end of the
throttle cable, and turn the adjuster to obtain the correct amount of play.
- Tighten the locknut.
(C)
(A). Adjustment.
(B). Lock nut.
(C). Throttle grip.
(D). Brake fluid reservoir.
- If the play can not be established by adjusting the cable, remove
the cable protection from the carburettor, adjust this using a tensioning
device at the end of the cable, tighten the lock nut and refit the
protection.
(D)
(A)
(B)