Accelerator Cable - GAS GAS EC250-F SUOMI User Manual

- Clean the filter in a
filter bath using a soft
brush.
- Check the air filter for damage such as scraping, hardening, shrinkage
If it is damaged then replace otherwise dirt will enter the throttle body.
- Grease all of the connections and bolts of the air filter and inlets.
- Fit the air filter to the motorcycle and ensure that it is correctly
connected.
- Squeeze it and take it
out with a clean cloth.
– Install the filter in the
cage and cover the filter
lip (A) with a thick layer
of grease to ensure a
seal and to avoid dust
penetration.
24
- -
THROTTLE CABLE
- Check that the throttle grip turns smoothly
- Check that the throttle grip has 2-3 mm of play.
- If the clearance is incorrect, pull out the rubber protection from the
tensioner (A), unlock the locknut (B) and adjust the tolerance with
the tensioner. Lock after the locknut and push the rubber protection
on it.
(C)
(D)
- If the play can not be
established by adjusting
the cable, remove the
cable protection from the
throttle, adjust this using a
(A). Adjustment.
tensioning device at the
(B). Lock nut.
end of the cable, tighten
(C). Throttle grip.
the lock nut and refit the
(D). Brake fluid reservoir.
protection.
NOTES:
Before the cable adjustment, you must adjust the idle.
WARNING:
After the adjustment, start the engine and turn the handlebar left
and right at the maximum, to check if the idle increase.
(A)
(B)