Accelerator Cable - GAS GAS FSE 450 - 2006 User Manual

- Clean the filter in a
filter bath using a soft
brush.
- Check the air filter for damage such as scraping, hardening, shrinkage
If it is damaged then replace otherwise dirt will enter the throttle body.
- Grease all of the connections and bolts of the air filter and inlets.
- Fit the air filter to the motorcycle and ensure that it is correctly
connected.
- Squeeze it and take it
out with a clean cloth.
– Install the filter in the
cage and cover the filter
lip (A) with a thick layer
of grease to ensure a
seal and to avoid dust
penetration.
24
- -
THROTTLE CABLE
- Check that the throttle grip turns smoothly
- Check that the throttle grip has 2-3 mm of play.
- If the play is incorrect, loosen the locknut on the upper end of the
throttle cable, and turn the adjuster to obtain the correct amount of
play.
- Tighten the locknut.
(C)
(A). Adjustment.
(B). Lock nut.
(C). Throttle grip.
(D). Brake fluid reservoir.
- If the play can not be established by adjusting the cable, remove
the cable protection from the throttle, adjust this using a tensioning
device at the end of the cable, tighten the lock nut and refit the
protection.
(B) (A) (D)