ASCOM OFFICE 130PRO Operating Instructions Manual page 26

Using the extended-feature functions
Requesting a call back
You request a call back from an internal subscriber whose line is busy or who is not
answering.
Note
Only one call back can be activated at a time.
Sending a message
Standard messages are stored in the PBX. After failing to reach a subscriber, you can
select one of these messages, add to it or change it if necessary and then send it to the
subscriber or a group you are trying to reach.
Msg.
M
1
C
4
7
1
4
7
Notes
• This procedure can also be initiated with "Dialling preparation", i.e. enter the number
first and then select the message.
• If you wish, you can also delete the entire message with the C-key and write your
own.
20
C–back
Reset
¥
Ok
2 3
5 6
8 9
0
Ok
2 3
5 6
8 9
0
Press the Foxkey under "Call_back". The
message "Call expected from the number nnn"
appears in the display.
By pressing the Foxkey under "Reset" you can
cancel the requested call back.
Press the M-key repeatedly until "Message"
appears. Press the Foxkey under "Message".
Press the Foxkey repeatedly under "¥" until a
suitable message appears (i-symbol on the
display).
Press i-key once or several times to display the
entire message.
Edit the message using the C-key and the
alphanumeric dialling keypad (if necessary, see
"Dialling with a name").
Press the Foxkey under "Ok".
Dial the number of the subscriber/the group to
whom the message is directed. Press the Foxkey
under "Ok" to send the message.
20317845en_ba_a0