Entering An Address Without Knowing The District/Suburb - ZENEC E GO Manual

1. Tap
2. Start entering the street name on the keyboard.
3. Get to the list of results:
After entering a couple of characters, the names that match the string appear in a
list.
Tap
4. Select the street from the list.
5. Enter the house number:
1. Tap
2. Enter the house number on the keyboard.
3. Tap
6. A list appears with the matching addresses. Tap the desired one.
7. The map appears with the selected point in the middle. Tap
menu. The route is then automatically calculated, and you can start navigating.

3.1.2.3 Entering an address without knowing the district/suburb

Long roads can run across several districts or suburbs. You may not know what particular house
number is located where. In this case, follow the instructions below:
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
2. By default, ZENEC Navigation Software proposes the country/state and settlement where you
are. If needed, tap the button with the name of the country/state, and select a different one
from the list.
3. If needed, change the settlement:
To select the settlement from the list of recently used ones, tap the
To enter a new settlement:
1. Tap the button with the name of the settlement, or if you have changed the
country/state, tap
2. Start entering the settlement name on the keyboard.
3. Get to the list of search results:
.
to open the list of results before it appears automatically.
.
to finish entering the address.
,
After entering a couple of characters, the names that match the string
appear in a list.
.
.
from the Cursor
button.
31