Entering An Address If House Numbering Is Restarted - ZENEC E GO Manual

3. Get to the list of results:
4. Select the street from the list.
5. Enter the house number:
1. Tap
2. Enter the house number on the keyboard.
3. Tap
6. The map appears with the selected point in the middle. Tap
menu. The route is then automatically calculated, and you can start navigating.

3.1.2.2 Entering an address if house numbering is restarted

There are long roads where house numbering is restarted at some point. This way the same house
number can appear twice or even more times on the same road. If this is the case, after entering the
house number, you need to select the appropriate address by the district/suburb information.
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
2. By default, ZENEC Navigation Software proposes the country/state and settlement where you
are. If needed, tap the button with the name of the country/state, and select a different one
from the list.
3. If needed, change the settlement:
To select the settlement from the list of recently used ones, tap the
To enter a new settlement:
1.
2.
3.
4.
4. Enter the street name:
30
After entering a couple of characters, the names that match the string appear in a
list.
Tap to open the list of results before it appears automatically.
.
to finish entering the address.
Tap the button with the name of the settlement, or if you have changed the
country/state, tap
Start entering the settlement name on the keyboard.
Get to the list of search results:
After entering a couple of characters, the names that match the string
appear in a list.
Tap
automatically.
Select the settlement from the list.
, .
.
to open the list of results before it appears
from the Cursor
button.