Operation; Operating The Remote Control Unit - Denon AVR-5800 Operating Instructions Manual

9 OPERATION

Before operating
3
3
1 Refer to "CONNECTIONS" (pages 6 to 13) and check that all
connections are correct.
2 To operate with the remote control unit, set the remote
control unit's screen to the "AVAMP 1/5" page.
3 Turn on the power.
Press the POWER operation switch (button).
ON / STANDBY
(Main unit)
• When pressed, the power turns on and the display lights. The
sound is muted for several seconds, after which the unit operates
normally.
• When pressed again, the power turns off, the standby mode is set
and the display turns off.
• Whenever the ON/STANDBY button is in the STANDBY state, the
apparatus is still connected to the AC line voltage. Please be sure
to unplug the cord when you leave home for, say, a vacation.
32
2
ON/STANDBY
(Remote control unit)

Operating the remote control unit

• For details, refer to the separate (supplied) RC-8000 operating
instructions.
1
Either lightly press on the remote control unit's touch panel
or press the LIGHT button to turn on the liquid crystal display.
2 Remote control unit's jog stick
Lightly press "ENTER" to display the icons.
Press the "
display the "AVAMP" icon.
Press the "AVAMP" icon to display the page section.
Lights
Move the remote control unit's jog stick "ENTER" left and
right to display the necessary page.
3
When the CURSOR/PAGE button is pressed and the display
is in half-tone dot mesh, the joystick operates as the cursor
up/down and left/right buttons and the ENTER button. (This
is called the cursor mode.)
The display switches between normal and half-tone dot
mesh each time the CURSOR/PAGE button is pressed, thus
switching between the page mode and the cursor mode.
(When the display is normal, the page mode is set.)
Normal display (page mode)
Half-tone dot mesh display (cursor mode)
" button on the icon display section to
Page feeding
Cursor up/down, left/right and
ENTER button