Chapter 2 Lan Installation; Procedure - TRENDnet TE100-P1U User Manual

Chapter 2
LAN Installation
This chapter describes how to install the Print Server in your Local Area Network.

Procedure

1. Preparation
•
Ensure the power is OFF. Do not connect the Print Server while power is On.
•
Find the Default Server Name for your Print Server. The Default Server Name is shown on
a sticker on the base of the device. It consists of 8 letters and/or digits. Record this name; it
may be needed during configuration.
2. Connect the Printer
•
For the TE100-P1U, use the cable supplied with your printer to connect the printer to the
USB port on the Print Server unit.
•
For the TE100-P1P, connect the male parallel port on the Print Server directly to the
printer.
3. Connect the Network Cable
•
Connect the network cable to the 10/100BaseT LAN connector on the Print Server.
4. Power Up
Plug in the power adapter cable and power up. Start-up will take only a few seconds.
Use only the Power Supply unit provided with the Print Server. Using a different Power
Supply may cause damage.
5. Check the LEDs
•
The Error LED should flash, then turn Off. When the Error LED goes off and the Status
LED remains lit or flashes, the Print Server is ready.
•
On the TE100-P1P, either the 10BaseT (yellow) LED or the 100BaseT (orange) LED
should be On.
•
On the TE100-P1U, the Error LED will remain flashing if the Print Server can't connect to
the USB printer.
Page 6