TRENDnet TE100-P1U User Manual page 18

If your Print Server is not listed:
•
Click the "Refresh" button.
•
Check that both the Print Server and the printer are properly connected, and
powered on.
•
Check that the Print Server has been configured. (Use the Setup Wizard on
the CD-ROM.)
•
If using TCP/IP, try installing the NetBEUI protocol. Then try again.
2. Select the desired port on a Print Server, then click Next. A pop-up message will inform
you if the port has been created successfully.
Figure 11: Print Port Setup (Peer-to-peer Printing)
If you see the following error message, either install Internet
Explorer 4 or later, or follow the procedure in the "Trouble
Shooting - Windows" section of Chapter 8.
Page 15