Main Menu; Initdevice Menu; Diagnostics Menu - TRENDnet TE100-P1U User Manual

Menus

Main Menu

Device Status
Printer Status
Configure
Upgrade
Refresh
Exit

InitDevice Menu

Reset Device
Restore to Factory
Default
Attached Remote
Connected
Protocol

Diagnostics menu

Print Test Page
Configuration
When the Configuration icon is clicked, or the Configure option on the Main menu is selected,
a tabbed window will open. The tabs available will vary depending on the Print Server model
selected. The possible tabs are:
•
System
•
TCP/IP
•
AppleTalk
•
NetBEUI
•
Internet Printing
•
Port
Same as Device Icon.
Same as Printer Status Icon.
Same as Configure Icon.
Same as Upgrade Icon.
Same as Refresh Icon.
Same as Exit Icon.
This will cause the device to reboot. This should be done after
making any configuration changes, or if the device stops responding
after some problems.
This will restore ALL device values to their factory defaults. To
restore only the current screen, use the Set to Default button on the
screen.
This is used to connect to a Print Server device on another LAN
segment. You need to know the IP address of the remote Print Server.
If your LAN does not have a Router, you can ignore this option.
This option allows you to designate which LAN protocol will be used
for communication between the selected device and this application.
You should select ONE protocol only.
Use this option to print a test sheet from the selected Print Server
port. The test print out will include status information.
Page 27