HP 615N - JetDirect Print Server Setup Manual page 38

Table C-1. EIO Classic Control Panel Menu (2 of 3)
Menu Item
CFG TCP/IP=
ENWW
Description
Selects whether you want to access the TCP/IP menu
and set TCP/IP protocol parameters.
NO (default): Bypass the TCP/IP menu items.
YES: Access the TCP/IP menu items.
TCP/IP menus depend on your print server model.
BOOTP=YES* enables configuration by a BootP
server.
DHCP=YES* enables configuration by a DHCP
server. If DHCP=YES* and the print server has
acquired a DHCP lease, you can choose to configure
the following DHCP settings:
RELEASE: Choose YES to release, or NO to save, the
current DHCP lease.
RENEW: Choose YES to renew the current DHCP lease,
or NO not to renew the DHCP lease.
AUTO IP=YES* will configure a link-local address.
In these cases, manual configuration is turned off.
If you specify BOOTP=NO, DHCP=NO, you can
choose AUTO IP=YES to have a link-local address
169.254.x.x assigned automatically.
If BOOTP, DHCP and AUTO IP are disabled, you can
manually set the following TCP/IP parameters from the
control panel:
Each byte of the IP address (IP)
Subnet Mask (SM)
Syslog Server (LG)
Default Gateway (GW)
Idle Timeout period (default is 270 seconds, 0 disables
the timeout)
(620n only) CFG DNS=YES* will allow you to
specify the IP address of a DNS server, one byte at
a time.
Print a Jetdirect configuration page to verify your
settings. However, note that the print server may
overwrite selected parameters with values that ensure
proper operation.
HP Jetdirect EIO Control Panel Menus 38