HP 615N - JetDirect Print Server Setup Manual page 39

Table C-1. EIO Classic Control Panel Menu (3 of 3)
Menu Item
CFG IPX/SPX=
CFG LINK=
WEB=
SECURITY=
ENWW
Description
Selects whether you want to access the IPX/SPX menu
and set IPX/SPX protocol parameters.
NO (default): Bypass the IPX/SPX menu items.
YES: Access the IPX/SPX menu items.
In the IPX/SPX menu, you can specify the Frame Type
parameter used on your network.
AUTO (default) will automatically set and limit the frame
type to the first one detected.
For Ethernet cards, frame type selections include
EN_8023, EN_II, EN_8022, EN_SNAP.
.
Selects whether you want to manually configure the
HP Jetdirect print server's network link.
NO (default): Bypass the link configuration menu
items.
YES: Access the link configuration menu items.
One of the following link configurations can be set:
AUTO (default): The print server will automatically
configure itself to match the network's link speed and
communication mode. If it fails, 100T HALF is set.
10T HALF: 10 Mbps, half-duplex operation.
10T FULL: 10 Mbps, full-duplex operation.
100T HALF: 100 Mbps, half-duplex operation
100T FULL: 100 Mbps, full-duplex operation
For configuration management, specify whether the
embedded Web server will accept communications
using HTTPS (Secure HTTP) only, or both HTTP and
HTTPS.
HTTPS: For secure, encrypted communications,
only HTTPS access is accepted. The print server
will appear as a secure site.
HTTP/HTTPS: Access using either HTTP or
HTTPS is permitted.
Specify whether the current security settings on the print
server will be saved or reset to factory defaults.
KEEP (default): The current security settings are
maintained.
RESET: Security settings are reset to factory
defaults.
HP Jetdirect EIO Control Panel Menus 39