Verify Jetdirect Print Server Operation; If Required, Configure Jetdirect With Your Network; Settings - HP 615N - JetDirect Print Server Setup Manual

Verify Jetdirect Print Server
Operation
1. Print a Jetdirect Configuration page and check for status
messages.
In most HP LaserJet printers, a Jetdirect Configuration page
will automatically print when you print a Printer Configuration
page.
In HP DesignJet printers, Jetdirect configuration information
will be included on the Service Configuration print.
2. In the first section of the Jetdirect Configuration Page, look for
the status message "I/O CARD READY". See
This section of the configuration page also contains product-
specific information, such as:
HP Jetdirect product number
Firmware revision number
LAN Hardware (MAC) address
Manufacturing identification number
Note
3. If I/O CARD READY appears, the card has been installed
successfully. Proceed to
Your Network
If I/O CARD READY does not appear, check that you have:
Installed the print server correctly and properly connected the
print server to the network
Verified that the network is operating properly
You can turn the printer off and then on again to reinitialize the
print server and try again.
ENWW
For a description of other messages that may appear
on the Jetdirect Configuration Page, refer to the
applicable HP Jetdirect Administrator's Guide
located on the HP Jetdirect CD-ROM.
If Required, Configure Jetdirect With

Settings.

Figure
Installation Procedures 12
2-2.