Steps To Connect The Towers - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

Before You Begin
CAUTION!
CAUTION! The SCSI
bus may be damaged if
you connect or
disconnect any units
when the power is on.
Optional:
Rack Mounting
Note
2-10 Installing Your Tower

Steps to Connect the Towers

•
Verify with your network administrator that a 10Base-T
(Ethernet) or 100Base-TX (Fast Ethernet) network connec-
tion is ready for the server/tower. Locate the twisted-pair
network cable (with an RJ-45 connector).
•
Verify that the tower's power is off.
•
Verify that the power supply input voltage is set according
to the power standards in the country of use; set the voltage
switch on the rear of the tower (see the illustration below) to
115 volts or 230 volts. Also verify that the power cord is
appropriate for the country of use (see page 2-2).
•
If you are extending the HP J3278A Server/Tower 7Plus
(using its rear SCSI connector illustrated below), you must
complete all cable and termination connections on the tow-
ers, and on any stand-alone drives used, before you apply
power to the towers or drives. Apply power to the 7-bay
tower, or other stand-alone drives, before you apply power to
the server/tower. See page 2-3 and page 2-4.
You can mount the tower in a rack using the HP C2982A
CD-ROM Tower Rackmount Kit.
1. Attach the power cord to the rear of the tower and to the
power line source. Do not switch on power yet.
If you are also installing the 7-bay HP C2988A SureStore
CD-ROM Tower (to the HP J3278A server/tower), now
install its power cord and then switch on its power.
Input voltage switch
Power cord connector
RJ-45 network connector
SCSI connector
(HP J3278A only)