HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 129

Replacing the Server Module
1. With the front cover off (see "Opening the Tower" on page 9-
17), slide the server out from the front of the top bay of the
tower—until the power supply, SCSI connector, and network
connectors are visible.
2. Remove the connectors from the server module, being careful
to not bend the ribbon cable or wires very deeply.
3. Return the server module using the warranty procedure
described in appendix B, "Warranty".
4. The replacement server module has a LAN hardware (MAC)
address that is different from the one recorded on the LAN
Address label on the (top of the) tower. It will be labeled on the
bottom of the replacement module.
5. To install the replacement module, you will install a package
of mounting rails with the included instructions, and then
reattach the connectors described above.
6. Replace the front cover by first hooking the flange of the cover
into the bottom of the tower case. Close the cover by pushing
it towards the main body of the tower. Lock the cover using the
key. Refer to the installation instructions in chapter 2 to
reinstall the server/tower on the network. Use the new LAN
hardware address when setting up network access again
(chapters 3–6).
Replacing the Tower Component
1. Before returning a faulty tower to HP, remove and retain all
CD-ROM drives and the server module, as described in the
previous three procedures.
2. Remove the LAN Address label, or copy and retain the
information recorded on it.
3. Return the tower in the product package. Use the warranty
procedure described in appendix B, "Warranty".
4. When you receive the replacement tower, record the old label
information on it (see step 2 above), or locate the LAN
hardware address on a label on the bottom of the server
module. The LAN hardware address is determined by the
existing server module.
5. Reinstall the replacement tower by reinstalling the server
module and CD-ROM drives (reversing previous steps).
Troubleshooting 9-19