Drive carrier
4. Reinstall the drive carrier into the enclosure.
5. Repeat steps 1 through 4 until all of your physical drives are installed.
2.3
Connecting the Ethernet Cable
To connect the NAS system to your network:
1. Attach one end of the network cable to an RJ45 network connector.
RJ45 Network
Connectors (2)
2. Attach the other end of the network cable to your Ethernet hub or
switch.
2.4
Connecting the Power
To connect and power up the NAS system:
1. Attach the power cord on the back of the enclosure.
2. Plug the other end into your power source.
Mounting screw
To avoid hand contact with an electrical hazard, remove
only one drive carrier a time.
Caution
10
Physical
drive
Screwdriver