3Com 3C905-TX Installation Manual page 12

Windows NT 4.0 Users
HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide
Software Installation Procedure
2 Ensure that you have the correct
may need to contact your MIS manager for this information.
3 Finally, double-click on each of your installed protocols and ensure
that your settings are correct for your PC's connection to the LAN.
You may need to contact your MIS manager for this information.
Software Installation and Update on a Windows NT 4.0 System
This section describes how to install the network driver in a PC running
Windows NT version 4.0 without the networking components installed.
You will need the following information from your MIS department:
Whether you are on a LAN or are connecting to one through a
•
modem
The protocol used in the Microsoft Windows Network (typically
•
TCP/IP or NetBEUI)
The name of the Windows NT server domain or workgroup you
•
belong to
Your IP address if you are using TCP/IP without DHCP
•
Installing the Driver from the EtherDisk
To install the network driver in a PC running Windows NT version 4.0:
1 Restart the PC and start Windows NT.
2 Double-click on the
icon.
Panel
3 In the
Control Panel
4 When prompted to install Windows NT Networking, click on
If you do not receive this prompt and the
window appears, Windows NT Networking is already installed. You
will need to add the adapter manually: click on the
click on and follow the instructions from step 7 onwards.
Add...
5 In the
Network Setup Wizard
on .
Next
12 English
Client
®
diskettes
icon, then double-click on the
My Computer
window, double-click on
window, select
and installed. You
Protocols
.
Network
control panel
Network
tab, then
Adapter
and click
Wired to the Network
Control
.
Yes