3Com 3C905-TX Installation Manual page 14

CAUTION
HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide
Software Installation Procedure
Installing the Driver from the Hard Disk (Advanced Users)
To install the network driver in a PC running Windows NT version 4.0
from driver files on the hard disk:
1 Restart the PC and start Windows NT.
2 Create a folder for the drivers, for example,
3 Insert EtherDisk
contents to your new folder.
4 Insert EtherDisk
contents to your new folder. If you are prompted to overwrite any
files click on .
Yes
5 Perform the installation from step 2 onwards of "Installing the Driver
from the EtherDisk® diskettes" on page 12. At step 8, specify the
folder that you copied the files to, for example,
Updating the Driver
If you already have the 3C905B-TX network driver and want to update
it, follow the instructions provided below.
1 Double-click on the
icon.
Panel
2 In the
Control Panel
3 In the window, click on the
Network
4 Highlight
3Com Fast EtherLink XL NIC (3C905B-TX)
5 Insert EtherDisk
prompt, then press E
6 Close the
Network
If a service pack was already installed on the PC before the network
interface card was installed, the service pack must be reinstalled. This will
overcome the
At Least One Service Failed to Start
started.
On some platforms you also need to reinstall certain drivers after installing
the Service Pack. Refer to your PC documentation for more information.
14 English
®
diskette #1 in your drive and copy the entire
®
diskette #2 in your drive and copy the entire
icon, then double-click on the
My Computer
window, double-click on
Adapter
®
diskette #1 in your drive and type
. The driver will be automatically updated.
NTER
window and restart the computer when prompted.
.
C:\LAN3COM
C:\LAN3COM\WINNT
.
Network
tab.
and click on
Update
at the
A:\
error when Windows NT is
.
Control
.