Memory Cannel Recall - Yaesu FT-847 Operating Manual

M C R
EMORY HANNEL
•
While operating in the VFO mode, press the [VFO/
M] switch momentarily. The transceiver will switch
into the "Memory" mode.
‚
Rotate the MEM/VFO CH knob to select the de-
sired Memory channel. Both the channel number
and frequency will appear on the display.
ƒ
To return to VFO operation, press the [VFO/M]
key once more.
Note: When "Split" memories are programmed,
the Transmit frequency does not appear
on the display until the transmitter is ac-
tivated. The frequency appearing on the
Sub VFO Display field is not the "Trans-
mit" frequency during "Split" memory
operation.
FT-847 O
PERATING
MEMORY OPERATION
M M
AIN
ECALL
M
ANUAL
S
EMORY YSTEM
Note: If you move the MAIN VFO Tuning Dial or the
SHUTTLE JOG™ ring while in the Memory
mode, you can change frequencies as if you were
in a "VFO" mode. When this is done, the "MT"
(Memory Tune) icon will appear on the display.
Press the [VFO/M] key once more to return to
the originally-stored Memory frequency.
While operating in the "MT" mode, if you want
to store a newly-tuned frequency, just follow the
procedures described previously for memory
storage (as though the "MT" mode were the
VFO mode). Just remember to select an unused
memory channel for storing the new frequency
data.
When operating on a "Split" frequency memory
(see previous page), the "+, –" indication will
appear on the display.
73