Erasing Individual Memories; Erasing All Memories - Yaesu FT-847 Operating Manual

Notes: The H channel memory system is capable
OME
of memorizing:
l Operating frequency
l Operating mode
l Receiver filter (Wide/Narrow)
l Clarifier information (direction and magnitude)
l Repeater shift information (direction and mag-
nitude)
l CTCSS Tone information (CTCSS Encode,
Decode On/Off; Tone Frequency)
l DCS information (DCS On/Off, DCS Code)
l Packet baud rate
If you move the MAIN VFO Tuning Dial or the MEM/
VFO CH knob while in the H
can change frequencies as if you were in the "M T "
mode. Press the [HOME] key once more to return to
the originally-stored Memory frequency.
While operating in the "pseudo-MT" mode, if you want
to store a newly-tuned frequency, just follow the pro-
cedures described previously for memory storage (as
though the "pseudo-MT" mode were the VFO mode).
Just remember to select an unused memory channel
for storing the new frequency data.
When operating on a "Split" frequency H
(see previous texts, the "+ , –" indication will appear
on the display.
Note
Regarding Recall of Home Channels
The H channel that will be recalled will de-
OME
pend on the last-used frequency band of opera-
tion. That is, if you are presently using a 144
MHz memory channel, pressing the [HOME]
key to switch to VFO operation on, for example,
14 MHz, pressing the [HOME] key will cause
the "HF Band" H
OME
FT-847 O
PERATING
MEMORY OPERATION
M M
AIN
channel mode, you
OME
memory
OME
channel to be recalled.
M
ANUAL
S
EMORY YSTEM
E I
RASING NDIVIDUAL
You may wish to clear the contents of a single memory
channel. The procedure to clear a memory of its data
is:
•
Press the [MCK/W] key momentarily.
‚
Rotate the MEM/VFO CH knob to select the
memory channel to be erased.
ƒ
Press the [REV] key. This will erase the data.
„
If you need to erase other channels, repeat steps
ƒ
and above.
...
Press the [MCK/W] key once more to exit to nor-
mal operation.
E A
RASING LL
If you wish to erase all memories (including all Satel-
lite Memory registers), and set the Main and Sub VFOs
to their default frequencies, use the following proce-
dure:
•
Press the [MENU] button to activate the Menu
mode of operation.
‚
Rotate the SUB-TUNE knob to select Menu #38
("MEM CLR ").
ƒ
Press the [MCK/W] key.
„
Press the [MENU] key to exit the Menu mode.
Note: This procedure does not reset the Menu System
to its factory defaults. See page 95 regarding
microprocessor reset procedures.
M
EMORIES
M
EMORIES
‚
75