Split-Frequency Memory Storage - Yaesu FT-847 Operating Manual

MEMORY OPERATION
S -F
PLIT REQUENCY
You can also store "Split" frequencies, such as when operating on a repeater system not utilizing a "standard"
offset. This procedure may also be used for DX work on 7 MHz SSB, etc.
•
In the VFO mode, set the Main VFO to the desired
Receive frequency and mode.
‚
Press the [MCK/W] key momentarily. A single
"beep" will be heard, and the "M CK" icon at the
top right-hand corner of the Main Frequency Dis-
play field will blink.
ƒ
Rotate the MEM/VFO CH knob to select the chan-
nel into which you wish to store the current fre-
quency data (in the above illustration, channel 62).
„
Press the [MCK/W] key once more for ½ second;
a double "beep" will again be heard, confirming
that the Receive frequency data is now stored.
...
Now set the Main VFO to the desired Transmit fre-
quency.
†
Press the [MCK/W] key for ½ second (you will
hear the double "beep"); do not rotate the MEM/
VFO CH knob!
‡
While the "6 2 " (channel number) indication is
blinking, press and hold in the microphone's PTT
switch; while holding in the PTT switch, again
press the [MCK/W] key for ½ second. The double
"beep" will confirm that independent Transmit fre-
quency data is now stored. You may now release
the [PTT] switch.
72
M M
AIN
M S
EMORY TORAGE
S
EMORY YSTEM
‡
Note: In step
not activate the transmitter. It simply sends a
signal to the microprocessor that an indepen-
dent Transmit frequency is being stored on the
same channel as a previously-stored Receive
frequency.
FT-847 O
above, pressing the PTT switch does
PERATING
M
ANUAL