Optional Voice Synthsizer Unit (Fvs-1A) - Yaesu FT-847 Operating Manual

Installation of Optional Accessories
I
NSTALLATION OF
•
Remove the two screws in the carrying handle and
the six screws affixing the covers (see Figure 3).
‚
Refer to Figure 4, remove the two front panel
mounting screws and loosen the two front panel
mounting screws, then fold the front panel down.
ƒ
Inside the front panel, locate the unconnected 10-
pin jack, and connect the FVS-1A here (see Figure
5).
„
Set the JApanese/ENglish switch on the FVS-1A
to the desired position, and then affix the FVS-1A
board into place using the double-sided adhesive
tape on the flat surface of the FVS-1A IC.
...
Fold the front panel back into place, and replace
the covers and carrying handle.
96
O V
PTIONAL OICE
S U
YNTHESIZER
Figure 3
Figure 4
Figure 5
FT-847 O
FVS-1A
NIT
M
PERATING ANUAL