Main Memory System; Normal ("Simplex") Memory Storage - Yaesu FT-847 Operating Manual

The Main Memory System of the FT-847 consists of memory channels 1 through 78, which provide the user with
a huge bank of memories for every operating need.
( "S " ) M
N
ORMAL IMPLEX
Use this procedure for storage of most frequencies, when not operating either in the "Split" nor "Satellite" mode.
•
Set the Main VFO to the frequency which you wish
to store in memory. Be sure that all mode, band-
width, and other conditions are set the way you want
them.
‚
Press the [MCK/W] key momentarily. The "M CK "
icon will blink at the top right-hand corner of the
Main Frequency Display field.
ƒ
Rotate the MEM/VFO CH knob to select an un-
used channel (one where no frequency display is
found). In the above illustration, this is channel 15.
„
Press the [MCK/W] ("Memory Check and/or
Write") key for ½ second. A double "beep" will be
heard, and the Main Frequency Display field will
revert to the VFO frequency. The double "beep"
confirms that the frequency data was stored. You
will still be operating in the "VFO" mode, so that
you can store additional frequencies into other
memory registers.
FT-847 O
PERATING
MEMORY OPERATION
M M
AIN EMORY
S
EMORY TORAGE
M
ANUAL
S
YSTEM
Notes: The Main Memory system is capable of memo-
rizing:
l Operating frequency
l Operating mode
l Receiver filter (Wide/Narrow)
l Clarifier information (direction and magni-
tude)
l Repeater shift information (direction and
magnitude)
l CTCSS Tone information (CTCSS Encode,
Decode On/Off; Tone Frequency)
l DCS information (DCS On/Off, DCS Code)
l Packet baud rate
Channels "L" and "U " are used as band limits for the
Programmable Memory Scan feature. See page 78 for
details.
71