Satellite Memory Alpha-Numeric Tag Programming - Yaesu FT-847 Operating Manual

Menu System
31 [TUNER]
Function:
Available Values: T
Default Setting: T
32 [MIC SCAN]
Function:
Available Values: O
Default Setting: O
33 [CW-N FIL]
Function:
Available Values: O
Default Setting: O
When the optional YF-115C CW Collins® Mechani-
cal Filter is installed, the microprocessor must be in-
structed to route the signal path via the YF-115C, in-
stead of via the SSB filter. Use this Menu selection to
do so. If the YF-115C is not installed, but Menu #33
is set to On, no signals will be heard when the [NAR]
key is pressed in the CW mode! Conversely, if the YF-
115C is installed, but Menu #33 is set to Off, the
[NAR] key will not respond when you push it.
88
M
ENU
Select the device (FC-20 or
ATAS-100) to be controlled via
the front panel's [TUNER] switch.
: The [TUNER] key
UNER
will activate the op-
tional FC-20.
ATAS-100:The [TUNER] key
will activate the op-
tional ATAS-100 Ac-
tive-Tuning Antenna
System.
UNER
Activate/deactivate the AutoScan
function of the microphone.
: Pressing and holding in the
N
microphone's [ UP ] or
[DWN] key for ½ second
will cause automatic scan-
ning to begin.
O : The scanner will scan only
FF
while [UP] or [DWN] key
is held down (the scanner
will halt if you release the
key).
N
Enable the CW signal path via the
optional YF-115C slot.
/O
N FF
FF
S D
ELECTION ETAILS
34 [SAT-MTR]
Function:
Available Values: D
Default Setting: P
The D setting is helpful in making frequency ad-
ISC
justments (due to Doppler Shift, etc.) when the down-
link signal from a satellite utilizes the FM mode.
35 [SAT TAG]
Function:
36 [AUTO-MEM]
Function:
Available Values: O
Default Setting: O
This selection ensures that Satellite-mode frequency
data is preserved when using that mode for the first
time (before "memorizing" any data), or immediately
following a microprocessor reset procedure.
37 [CAT RATE]
Function:
Available Values: 4800/9600/57600 bps
Default Setting: 4800 bps
38 [MEM CLR]
Function:
While in this Menu selection, pressing the [MCK/W]
key causes all Memories to be cleared, but any cus-
tom Menu settings you have programmed will not be
affected.
Set mode of the meter's lower scale
(below S-meter) during Satellite
operation.
: Display of Discriminator
ISC
centering (of incoming sig-
nal) for frequency adjustm-
ent purposes.
P : Display of transmitter
O
Power Output.
A : Display of transmitter ALC
LC
voltage.
O
Store Alpha-Numeric "Tags" for
the Satellite Memories.
Up to 8 characters may be stored,
for the purpose of labeling the Sat-
ellite Memories for easier tran-
sponder-mode identification. The
storage procedure is shown next
page.
Activate/deactivate the Satellite
Automatic Memory feature.
/O
N FF
FF
Set the data transfer rate during
CAT
(Computer Aided Trans-
ceiver) control operation.
Clear all memories.
FT-847 O
PERATING
M
ANUAL