Yaesu FT-847 Operating Manual page 88

Menu System
18 [VHF-RPT]
Function:
Available Values: 0.00 ~ 99.99 MHz
Default Setting: 0.60 MHz (600 kHz)
Any attempt to set a shift greater than 4 MHz will re-
sult in an "E " message when you transmit, as the
RROR
resulting transmit frequency would be outside the
amateur band.
19 [UHF-RPT]
Function:
Available Values: 0.00 ~ 99.99 MHz
Default Setting: 5.00 MHz
Any attempt to set a shift greater than 20 MHz will
result in an "E
RROR
the resulting transmit frequency would be outside the
amateur band.
20 [MONI-VOL]
Function:
Available Values: 0 ~ 63 (arbitrary scale)
Default Setting: 16
The Monitor Level setting is established via this Menu
item, and does not depend on the setting of the AF
(G ) control.
AIN
21 [BEEP-FRQ]
Function:
Available Values: 440/880 Hz
Default Setting: 880 Hz
22 [BEEP-VOL]
Function:
Available Values: 0 ~ 63 (arbitrary scale)
Default Setting: 32
The Beep Level setting is fixed via this Menu item,
and does not depend on the setting of the AF (G
control.
86
M
ENU
Set the magnitude of the Repeater
Shift to be utilized when operat-
ing on the 144 MHz band.
Set the magnitude of the Repeater
Shift to be utilized when operat-
ing on the 430 MHz band.
" message when you transmit, as
Set the audio level for the SSB
Monitor.
Set the frequency of the "Beep"
tone which sounds when a front
panel key is pressed.
Set the audio level of the "Beep"
tone which sounds when a front
panel key is pressed.
S D
ELECTION ETAILS
23 [PKT RATE]
Function:
Available Values: 1200/9600 bps
Default Setting: 1200 bps
The rear-panel PKT jack's connections are optimized
for the different bandwidth, level, and impedance val-
ues typically utilized on 1200 bps and 9600 bps. This
Menu selection instructs the microprocessor as to
which connections to utilize.
24 [TX-MTR]
Function:
Available Values: P
Default Setting: P
The ALC meter indication includes the transceiver's
ALC plus any external ALC voltage which may be
fed to the FT-847 from an external linear amplifier.
25 [FM P-SET]
Function:
Available Values: O
Default Setting: 32
The O setting selects control of the FM Microphone
FF
Gain via the front-panel MIC (G
adjustment is also possible via the 0 ~ 63 arbitrary
scale; use a Deviation Meter to establish the proper
level.
26 [RESUME]
Function:
Available Values: O
Default Setting: 5 seconds
In the O position, scanning will resume after the other
FF
station stops transmitting (carrier drops). In the other
settings, the scanner will resume scanning after a fixed
interval set through this Menu item, whether or not
the other station is still transmitting.
)
AIN
Set the transceiver's circuitry for
the Packet baud rate to be used.
Set the function for the transmit-
mode meter indication.
: Indication of Power Output
O
A : Indication of ALC voltage
LC
O
Set the Mic Gain level for the FM
mode.
or 0 ~ 63 (arbitrary scale)
FF
) control. Manual
AIN
Set the Scan-Resume mode and
time delay.
/3/5/10 seconds
FF
FT-847 O
PERATING
M
ANUAL