How To Select And Set Up The Sensors - Simrad PI50 - REFERENCE MANUAL REV A Reference Manual

Simrad PI50
2 Click the
User Settings
→ User Settings on page 121
3 In the
User Settings
•
Simrad Factory Default
•
Simrad Purse Setup
•
Simrad Trawl Setup
Click the
4
Activate Selected Setting

How to select and set up the sensors

The PI50 allows you to put the entire PI sensor range to use. However, you must select
the sensors that you wish to use, set them up in the order you wish to see them on
the screen, and select the operational parameters. Both the sensor selection and the
parameter setup are done in the
→ Select Sensors on page 142
Click the icon under the
1
Setup
→ Setup menu on page 119
2 Click the
Select Sensors
→ Select Sensors on page 142
3 Observe the
Available Sensors
the sensor types supported by the PI50.
4 Click once a sensor type to select it.
5 Click the [►] button to copy the chosen sensor to the
6 Repeat to select all requested sensors.
The PI50 system will keep track of the quantity of sensors you are adding to the
Selected Sensors
If you need to delete a sensor from the
click the [◄] button.
In the
7
Select Sensors
24
button to open the
dialog, click one of the factory settings in the top text field:
, then click
Select Sensors
menu to open the
Main
button to open the
field on the upper left side of the dialog. It lists all
list. If you try to add too many sensors, a message will let you know.
dialog, observe the items in the
dialog.
User Settings
.
Close
dialog.
Setup
dialog.
Select Sensors
Selected Sensors
list, click on it, and then
Selected Sensors
Selected Sensors
sub-menu.
list.
list.
328458/A