User Card Window - Simrad NX40 Installation & Operation Manual

CAUTION
!
WARNING
!
16

User card window

DANGER
CAUTION
Before using a user card,
remove any chart card
and plug the user card in.
When you have finished
with the user
remove the user card and
replace the chart card.
60
A user card is an optional plug-in card that can store
data files. There are three types of files: waypoints,
routes or a track.
To go to the user card window
card,
The user card window has:
File list
A list of the files on any user card in the unit.
To scroll up or down a page at a time
Waypoints, Routes
The number of waypoints and routes currently in the
unit.
Track 1 to Track 10
The number of points in tracks 1 to 10 currently in the
unit.
Note:
• To save data onto the user card, use the Save
command (see below).
• Data stored on the user card and shown on the file
list is not available to be used by the unit until loaded
into the unit with the LOAD command (see below).
Saving data to the user card
This saves all the unit's waypoints, all the unit's routes or
one of the unit's tracks to one file on the user card. For
Tracks, select the track number to save.
The new file is created. Change the name if required.
The new file appears in the file list.
Loading data from the user card to the unit
This loads one file from the user card to the unit:
• A waypoints file: The new waypoints are added to
any existing waypoints in the unit. If a new waypoint
has the same name as an existing waypoint but has
Simrad NX40/45 Installation and Operation Manual
> >
More User card
> >
Save Waypts
or or
Routes Tracks