Simrad NX40 Installation & Operation Manual page 98

Dash
98
Note: the 5 x 14G self tapping screws are for bracket
mounting only.
•
Bracket Mounting the NX40/45
An alternative to flush mounting the NX40/45 is to
bracket mount the unit. This method has the advantage
that the display can be easily removed when it is not in
use. The display may be tilted for best possible viewing
angle when bracket mounted.
Note: The mounting bracket does not allow for rotation
of the unit to the left and right.
•
•
•
•
•
Bezel 8 gauge screws
Simrad NX40/45 Installation and Operation Manual
To finish off the installation firmly clip the front bezel
in place.
Use the mounting bracket as a template to mark the
5 positions of the screw holes.
Select a suitable drill bit (note: larger diameter pilot
holes may be required if mounting to fiberglass) and
drill 5 pilot holes in the marked positions.
Secure the mounting bracket using the 5 x 14G self
tapping screws.
Slide the NX40/45 into the mounting bracket and
secure in place with the bracket knobs.
To finish off the installation firmly clip the front bezel
in place.
Knob
Mounting bracket