DRAWING FILE
Echo sounder connections
130003/D
This chapter contains relevant drawings related to the electrical
and physical installation of the Simrad 38-7 Single beam
transducer.
Note
The mechanical drawings are for information and guidance only.
They are not in scale, and may differ slightly from the original
drawings. All dimensions are in mm unless otherwise is noted.
The original installation drawings are available on PDF and/or
DWG (AutoCad) format. Visit
Topics
•
Echo sounder connections on page 29
Outline dimensions and installation drawings on page 32
•
Observe the following information related to electrical
connection of the 38-7 Single beam transducer.
Splicing the transducer cable
If you need to splice the transducer cable, it is very important
to use the correct cable, and to avoid ground loops. We strongly
recommend the use of a junction box. We also recommend that
you install the transducer cable in a steel conduit.
For more information, see:
•
Transducer cable splicing on page 28
•
Steel conduit on page 22
•
General Purpose Transceiver (GPT) transducer plug
assembly on page 31
www.simrad.com
to download.
Drawing file
29