Simrad ES70-7C
DRAWING FILE
Echo sounder connections
36
This chapter contains relevant drawings related to the electrical
and physical installation of the ES70-7C Split-beam transducer.
Note
The mechanical drawings are for information and guidance only.
They are not in scale. All dimensions are in mm unless otherwise
is noted.
The original installation drawings are available on PDF and/or
AutoCad format. Visit
Topics
•
Echo sounder connections on page 36
•
Outline dimensions and installation drawings on page 39
Observe the following information related to electrical
connection of the ES70-7C Split-beam transducer.
Topics
•
Splicing the transducer cable on page 36
•
General Purpose Transceiver (GPT) wiring on page 37
•
General Purpose Transceiver (GPT) transducer plug
assembly on page 38
Splicing the transducer cable
If you need to splice the transducer cable, it is very important
to use the correct cable, and to avoid ground loops. We strongly
recommend the use of a junction box. We also recommend that
you install the transducer cable in a steel conduit.
Related topics
•
Transducer cable splicing on page 29
•
Steel conduit on page 30
•
General Purpose Transceiver (GPT) transducer plug
assembly on page 38
www.simrad.com
to download.
307324/B