Drawing File; Echo Sounder Connections; Splicing The Transducer Cable - Simrad ES333-7CD - INSTALLATION REV A Installation Manual

200 khz split-beam deep water transducer

Hide thumbs Also See for ES333-7CD - INSTALLATION REV A:

Table of Contents

Simrad ES333-7CD

DRAWING FILE

This chapter contains relevant drawings related to the electrical

and physical installation of the ES333-7CD Split-beam

transducer.

Note

The mechanical drawings are for information and guidance only.

They are not in scale. All dimensions are in mm unless otherwise

is noted.

The original installation drawings are available on PDF and/or

AutoCad format. Visit

Topics

• Echo sounder connections on page 20

• Outline dimensions and installation drawings on page 23

Observe the following information related to electrical

connection of the ES333-7CD Split-beam transducer.

Topics

• Splicing the transducer cable on page 20

• General Purpose Transceiver (GPT) wiring on page 21

• General Purpose Transceiver (GPT) transducer plug assembly

on page 22

If you need to splice the transducer cable, it is very important to

use the correct cable, and to avoid ground loops. We strongly

recommend the use of a junction box. We also recommend that

you install the transducer cable in a steel conduit.