Drawing File; Echo Sounder Connections; Splicing The Transducer Cable - Simrad ES38-12 - INSTALLATION REV A Installation Manual

This chapter contains relevant drawings related to the electrical and physical installation
of the Simrad ES38-12 Split beam transducer.
Note
The mechanical drawings are for information and guidance only. They are not in scale,
and may differ slightly from the original drawings. All dimensions are in mm unless
otherwise is noted.
The original installation drawings are available on PDF and/or DWG (AutoCad) format.
Visit www.simrad.com
Topics
• Echo sounder connections on page 33
• ES38-12 Outline dimensions and installation drawings on page 36

Echo sounder connections

Observe the following information related to electrical connection of the ES38-12 Split
beam transducer.

Splicing the transducer cable

If you need to splice the transducer cable, it is very important to use the correct cable,
and to avoid ground loops. We strongly recommend the use of a junction box. We also
recommend that you install the transducer cable in a steel conduit.
For more information, see:
• Transducer cable splicing on page 32
• Steel conduit on page 25
• General Purpose Transceiver (GPT) transducer plug assembly on page 35
344276/A
to download.

Drawing file

Drawing file
33