Table of Contents
Advertisement
Retractable transducer
130003/D
Hull units allowing the transducer to be lowered and hoisted are
commonly used for horizontal looking sonars. When not in use,
the transducer is retracted into a trunk.
The retractable hull unit is more expensive than a blister, but on
vessels with a hull where it is difficult or impossible to install a
blister, it may still be worth while. The principles of a hull unit
with a retractable transducer is shown below.
Vessels without a keel and with a wide, flat bottom is an example
where a retractable hull unit can be the only acceptable method
for bringing the echo sounder transducer below the boundary
layer.
How to install the transducer
A
Transducer
Trunk
B
C
Transducer
shaft
D
Transducer
shaft sleeve
Keel
E
21
Advertisement
Table of Contents
