Cable Gland For Wooden And Grp Hulls - Simrad 38-200 COMBI W - INSTALLATION REV D Installation Manual

Simrad 38/200 Combi W

Cable gland for wooden and GRP hulls

24
A bronze cable gland kit is available for wooden and
glass-reinforced plastic (GRP) vessels.
A Packing nipple. Make sure that you do not damage the
transducer cable by tightening the packing nipple too hard!
Washers
B
Rubber gaskets
C
Hole diameter 28 mm
D
Steel conduit
E
Cable to the echo sounder (or a junction box)
F
The cable gland kit includes all of the necessary parts needed to
install the unit except screws.
Simrad recommends that a one inch steel conduit (that the
transducer cable will be run through) with an inside threaded
diameter of three-quarter inches is attached to the gland's packing
nipple. This connection must be watertight, and the conduit must
extend to above the vessel's water line.
164986/D