Drawing File; Echo Sounder Connections; Splicing The Transducer Cable - Simrad 38-200 COMBI W - INSTALLATION REV D Installation Manual

DRAWING FILE

Echo sounder connections

164986/D
This chapter contains relevant drawings related to the electrical
and physical installation of the Simrad 38/200 Combi W Dual
frequency transducer.
Note
The mechanical drawings are for information and guidance only.
They are not in scale, and may differ slightly from the original
drawings. All dimensions are in mm unless otherwise is noted.
The original installation drawings are available on PDF and/or
DWG (AutoCad) format. Visit
Topics
• Echo sounder connections on page 33
• Outline dimensions and installation drawings on page 36
Observe the following information related to electrical
connection of the 38/200 Combi W Dual frequency transducer.

Splicing the transducer cable

If you need to splice the transducer cable, it is very important
to use the correct cable, and to avoid ground loops. We strongly
recommend the use of a junction box. We also recommend that
you install the transducer cable in a steel conduit.
For more information, see:
• Transducer cable splicing on page 26
Steel conduit on page 27
•
• General Purpose Transceiver (GPT) transducer plug
assembly on page 35
Drawing file
www.simrad.com to download.
33