Table of Contents
Advertisement
Simrad ES38-18/200-18CR Installation Manual
Installing the transducer cable
When the transducer has been placed under its mounting location, the cable can be
pulled through the cable gland and stuffing tube, and then through the steel conduit up
to the transceiver.
Prerequisites
Before you can do this task, the following prerequisites must be met:
• All relevant work instructions, procedures and standards must be available.
• The stuffing tube has been installed.
• The steel conduit is mounted with all installation work finalized.
• All relevant drawings have been approved by the classification society.
• All relevant personnel (skilled shipyard workers, ship electricians) and their tools
must be available.
You must be equipped with a standard set of tools. This tool set must comprise the
normal tools for electronic and electromechanical tasks. This includes different
screwdriver types, pliers, spanners, a cable stripper, a soldering iron etc. We recommend
that all tools are demagnetized to protect your equipment. The following specific
consumables are required for this task:
• Fish tape (wire pulling tool) with suitable length
• Electrician's tape
• Wire wraps
Context
The transducer cable is provided with fixed length. The stuffing tube and the associated
parts are included in the delivery.
Note
All necessary precautions must be made to avoid damage to the cable while pulling it
through the steel conduit. Make sure that all welding has been finalized before you
pull the cable through the steel conduit. Heat may cause serious damage to the cable
and the transducer.
These items are all provided as a part of the transducer delivery.
28
436200/A
Advertisement
Table of Contents
