Table of Contents
Advertisement
Cable gland for wooden and GRP hulls
330254/A
A bronze cable gland kit is available for wooden and GRP
vessels.
A
Packing nipple. Make sure that you do not damage the
transducer cable by tightening the packing nipple too hard!
Washers
B
C
Rubber gaskets
Hole diameter 28 mm
D
E
Steel conduit
F
Cable to the echo sounder (or a junction box)
The cable gland kit includes all of the necessary parts needed to
install the unit except screws.
Simrad recommends that a one inch steel conduit (that the
transducer cable will be run through) with an inside threaded
diameter of three-quarter inches is attached to the gland's packing
nipple. This connection must be watertight, and the conduit must
extend to above the vessel's water line.
Transducer cable glands and splicing
27
Advertisement
Table of Contents
