Cable Glands For Small Hulls - Simrad 38-200 COMBI W - INSTALLATION REV D Installation Manual

Cable glands for small hulls

164986/D
This cable glands made of plastic is designed for those smaller
vessels that do not need to be classified.
A Packing nut (bronze). Make sure that you do not to damage
the transducer cable by tightening the packing nut too hard!
Rubber gasket
B
Plastic disk
C
Rubber gasket
D
E Stuffing tube
F Backing nut (bronze)
G Backing washer (plastic)
H O-ring 42.5 x 3.0 N
I O-ring 39.5 x 3.0 N
J Cable to the echo sounder (or a junction box)
Stuffing tube hole diameter: 36 mm ±1.5 mm.
Apply ample amount of sealant between the backing washer (H)
and the hull plate.
The cable gland kit contains all the listed parts, except the sealant.
Note
The two O-rings must be clean, in good condition and free of cuts
or other defects which could affect their watertight integrity.
Transducer cable glands and splicing
25