Transport - Sharp 3800M - B/W Laser - All-in-One Operation Manual

When moving the machine, follow the procedure below.
When moving this machine, be sure to remove the TD cartridge. This
prevents toner from spilling inside the machine during shipment.
1
Turn the power switch off and disconnect the power cord.
Remove the printer interface cable.
2
Push gently on both sides of the front cover to open the cover.
3
Gently pull the TD cartridge out. See page 29, TD CARTRIDGE REPLACE-
4
MENT.
Remove the copy paper from the paper tray. To remove the paper, see page
5
35, Misfeed in the paper tray.
Remove the paper tray from the machine.
6
Gently push the paper output tray back into the machine until it stops.
7
Attach to the left side of the machine the screw that has been saved. See
8
page 3, SET UP.
When shipping the machine, the screw must be reinstalled to prevent
shipping damage. This screw will secure the scanning head. If the
power has been turned off while an original was being scanned, the
scanning head is not at the left end position. In this case, turn on the
machine and then turn it off after checking the head is at the left end
position.
14
9
Close the front cover.
Attach the packing materials and tape which were removed during
10
installation of the machine See page 3, SET UP
Pack the machine into the carton.
11
130
SUK 14 SPECIFICATIONS LEO.p65

Transport

SPECIFICATIONS
130
.
30/03/00, 17:27