Automaticexposure Adjustment - Sharp 3800M - B/W Laser - All-in-One Operation Manual

Automatic exposure adjustment
The automatic exposure level can be adjusted to suit your copying needs.This
level is set for copying from the original table and copying from the SPF
respectively.
When adjusting the automatic exposure level for copying from the SPF,
1
place an oriignal in thedocument feeder tray and make sure that the
SPF( ) indicator lights up.
When adjusting the level for copying from the original table, make sure that
no original is left in the document feeder tray.
Press the exposure mode selector key to select the photo (
2
Press and hold down the exposure mode selector key for approximately
3
5 seconds.
The photo (
blink. One or two exposure indicators corresponding to the automatic
exposure level which has been selected will light up.
Press the light ( { ) or dark ( } ) key to lighten or darken the automatic
4
exposure level as desired.
If exposure level 2 is selected, the two left-handmost indicators for that
level will light up simultaneously. Also, if level 4 is selected, the two right-
handmost indicators for that level will light up simultaneously.
Press the exposure selector key. The AUTO indicator will stop blinking
5
and light up steadily.
This automatic exposure level will remain in effect until you change it
again by this procedure.
SUK 02 MAKING COPIES LEO.p65
) indicator will go out and the AUTO indicator will begin to
MAKING COPIES
21
) mode.
21
30/03/00, 16:37
2