Connecting The Interface Cable - Sharp 3800M - B/W Laser - All-in-One Operation Manual

Connecting the interface cab Connecting the interface cable le le le le Connecting the interface cab
Connecting the interface cab Connecting the interface cab
To use the FO-3800M as a laser printer or scanner, connect it to your computer
using a prallel interface cable.
Use the parallel interface cable included with the FO-3800M.
For specifications of the parallel interface, see page 128.
Check that the power switches of both the machine and the computer
1
are in the OFF position.
Plug the parallel interface cable into the printer interface connector.
2
Fasten the two bail clips at the side of the printer connector to hold the
interface connector in place.
Plug the other end of the cable into the parallel interface connector on
3
your computer. (Refer to your computer manual for details.)
Parallel interface
connector
Cable
This machine sends and receives data bi-directionally and at high
speed. Some switch boxes and pass-through devices cannot
support high-speed, bi directional transfer of data, and using them
may cause printing errors.
UK 10 PREPARATION LEO.p65
Interface connector
GETTING STARTED
103
Bail clip
30/03/00, 17:09
10
103 103 103 103 103