Go Rhino HitchStep 360 Series Installation Instructions

HitchStep
View of HitchStep from above
View of HitchStep
Insert the Hitch Step post into the vehicle's hitch receiver.
The Hitch Step has 3 holes for alignment. Position the
HitchStep to your liking and align up the nearest hole with
the hole in the receiver. Push hitch pin through the holes
and secure with the hitch pin clip provided. Note: You may
prefer to use a locking hitch pin, any popular make will work
with the HitchStep.
If you need to use the receiver for towing, remove the
HitchStep and replace with your tow hitch. When the
GORHINO.COM
™ Installation Instructions
Hitch pin
HitchStep
�
HitchStep
Vehicle hitch receiver
™
from side of the vehicle
The Go Rhino HitchStep
easy to install requiring no special tools.
GO RHINO
589 W. Apollo St. Brea, CA
(888) 427-4466
Hitch pin clip
/
WARNING - HitchStep
of the O.E. back-up sensor on several late model
vehicles. If your vehicle comes equipped with an 0.E.
back-up sensor, it is advised that you check its
functionality after installation.
Install this product at your own risk.
™ is quick and
HitchStep is not in use, it can be stored in the storage bag
provided. This will keep the inside of your vehicle clean. The
HitchStep should be cleaned and cared for in the same
manner that you clean and care for your vehicle. Do not use
abrasive cleaners on the finish. In extreme weather
conditions, you may wish to lubricate the anti­rattle clamp
knob thread with WD40 or grease. Thank you for choosing
Go Rhino. Check out our other products on our website at
gorhino.com.
92821
FAX: (714) 529-5252
Anti-rattle strap
Anti-rattle
\
Anti-rattle clamp knob
™
may interfere with the operation
© 2016 Go Rhino