Ballard Designs Ines SC442 Assembly Instructions

PRODUCT NAME: Ines Sideboard
ITEM NUMBER: SC442
ASSEMBLED DIMENSIONS : 35"H x 72"W x 16.75"D
1
LEVELERS: Sideboard is equipped with Rotary
Levelers installed under each leg. If necessary
adjustments may be made by carefully lifting
applicable corner and turning Levelers clock-
wise/counterclockwise.
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alcohol based
cleaners or polishers. Promptly remove spills.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-4-2024
NOTE
Set furniture into place and level
before anchoring to wall.
Cleaning and Care
Serious or fatal crushing injuries can occur from a furniture tip-over
Prevent tipping accidents. Anchor your furniture.
REQUIRED TOOLS: Phillips Screwdriver (Anchoring)
NO ASSEMBLY REQUIRED
ASSEMBLED WEIGHT: 185 lbs.
Ltr. Qty. Hardware/Components Included
A
12
B 12
2
C
D
3
2
Insert Shelf Supports (A). Set Shelf (D)
level upon supports. Secure with Screw (B)
FULLY REMOVING DRAWERS
Drawers feature undermount metal glides.
First, fully open/extend drawer then reach under
each front corner and pull latches to release
Lift drawer up and out.
To replace, align glides and push drawer in.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
WARNING
Tip-Over Hazard
ANCHORING HARDWARE INCLUDED
Shelf Supports
Wood Screws
(#3.5 x 5/8")
Wall Anchoring
(Anti-tip) Kit
See page 2
Shelves
(A)
(B)
(D)
drawer from glides.
Latches (front corners)
Drawer Underside
MADE IN VIETNAM
(D)
Page 1 of 2