Advertisement
Quick Links
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
PRODUCT NAME: Tuscan Desk Return (Top, Cabinet, Leg)
ITEM NUMBER: MO255 (Includes MO251 & MO254)
ASSEMBLED DIMENSIONS : 30"H x 72"W x 36"D
PRODUCTS ARE NOT INTENDED
IMPORTED
FOR COMMERCIAL USE.
UPDATED: 6-12-2019
Page 1 of 6
Advertisement
Related Manuals for Ballard Designs MO255
Summary of Contents for Ballard Designs MO255
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Tuscan Desk Return (Top, Cabinet, Leg) ITEM NUMBER: MO255 (Includes MO251 & MO254) ASSEMBLED DIMENSIONS : 30”H x 72”W x 36”D PRODUCTS ARE NOT INTENDED IMPORTED FOR COMMERCIAL USE. UPDATED: 6-12-2019 Page 1 of 6...
- Page 2 Return Desk comprised of two parts, MO254 Desk Top/Leg and MO251 Base Cabinet. Illustration below shows location of parts and hardware. MO254: Desk Top (H), Leg (I) Hardware Packet and Hardware Packet. MO251: Base Cabinet (K) and Shelf (J). Shelf and Shelf Supports located on underside of Base Cabinet.
-
Page 3: Tools Needed
TOOLS NEEDED: Ltr. Qty. Hardware Included Allen Wrench (included) Long Allen Bolt (A) Screwdriver for Anti-Tip Hardware 35mm to ATTACH LEG -Two person assembly suggested. Short Allen Bolt (B) 29mm to ATTACH CABINET Remove all parts, hardware and protective packaging from carton Lock Washer (C) and carefully arrange on a clean, level, padded surface. - Page 4 NOTE: Assemble desk in location for intended use. STEP 1: Orient Base Cabinet (K) in preferred direction and remove top drawer. Next, gently lower Desk Top (H) onto Base Cabinet and Leg (I). Place Leg on Apron end of Desk Top. Apron TO REMOVE DRAWERS Push Black Lever on each rail up on one side...
- Page 5 STEP 3: Gently insert Shelf Supports (F) into pre-drilled holes. Place Shelf (J) into Base Cabinet (K). STEP 4: If necessary, desk may be leveled by adjusting Rotary Levelers located under each corner. Turn clockwise/counterclockwise until desk is level. Cleaning & Care: DO NOT use alcohol based products or spray polisher as finish damage may result.
- Page 6 Anti Tip Installation Part C: Where applicable, attach desk to wall. Ltr. Qty. Hardware Included Small Screw Large Screw Bracket Retention Belt Attach 2 Brackets (C) through the smaller holes to Desk with Small Screws (A) Attach remaining Brackets (C) INTO A WALL STUD with Large Screws (B) 2 inches below the Brackets attached to Desk.