Resetting Target Trails; Trail Copy - Furuno FA Manual

1.28.4

Resetting target trails

You may clear all target trails to restart the trail process. Target trails are cleared
and the trailing process restarts from time count zero at the current target trail
plot interval.
1. Roll the trackball to place the arrow on the TRAIL MODE box at the bottom
right corner of the screen.
2. Push the right button to display the TRAIL menu.
3. Roll the wheel to choose 5 TRAIL RESTART and then push the wheel or the
left button.
4. Roll the wheel to choose ON or OFF as appropriate and then push the wheel
or the left button.
ON: Trails start extending on the newly selected range.
OFF: Trails are shown and extend only on the range where they were
initiated.
5. Push the right button to close the menu.
1.28.5

Trail copy

Trails are canceled and restarted whenever the range is changed. However, you
may continue trails on the same range, without restarting them, when the range
is changed to a next larger or smaller range scale. Note however that when the
range is changed, only those trails within the previous range are continued; no
trails are generated for targets outside the previous range.
1. Roll the trackball to place the arrow on the TRAIL MODE box at the bottom
right corner of the screen.
2. Push the right button to display the TRAIL menu.
3. Roll the wheel to choose 6 TRAIL COPY and then push the wheel or the left
button.
4. Roll the wheel to choose ON or OFF as appropriate and then push the wheel
or the left button.
5. Push the right button to close the menu.
No trail generated
for target not within
previous range
(a) Previous range
(b) New range
Trail copy
1. RADAR OPERATION
1-51