Displaying Antenna Information - Furuno FA Manual

1. RADAR OPERATION
1.44.2

Displaying antenna information

The antenna information display shows data (radar band, model and position) on
the radar antennas currently powered. If an antenna is not powered, its data
area is blank.
1. Roll the trackball to place the arrow in the ANTENNA box at the left side of
the screen.
2. Push the left button to choose the antenna for which you want to find
information. (You cannot choose an antenna which does not exist or one
which is not powered.)
3. Push the right button to show the antenna information display.
[ANT INFORMATION]
ANT NO 1
BAND
MODEL : 12 UP
POS
ANT NO 2
BAND
MODEL : 25 UP
POS
ANT NO 3
BAND
MODEL : 30 UP
POS
ANT NO 4
BAND
MODEL :
POS
OWN RADAR NO.
4. Push the right button to close the antenna information display.
The interswitch function permits control of all antennas from any display, using
an Ethernet In the antenna system configuration shown above, for example,
ANT1 can be controlled directly from DISPLAY-A, and also can be controlled
from other displays, via the Ethernet. Further, if ANT1 is out of order or its power
has been turned off, any display can switch to ANT2 or ANT3. The ANT
INFORMATION display shows which antennas can be used. Refer to it to know
antenna status.
1-86
: X-BAND
: FORE
: X-BAND
: MAIN TOP
: S-BAND
: MAIN 2ND
:
:
ANTENNA INFORMATION display
Using the information shown on the antenna
information display at left, the antenna system
configuration looks as below.
ANT1 ANT2
DISP-A
Ethernet
HUB
ANT3
DISP-B DISP-C