Extron electronics NAV E 111 DTP3 Setup Manual

NAV E 111 DTP3 • Setup Guide
IMPORTANT NOTE:
Go to www.extron.com
before connecting the product to the power source.
This guide provides instructions for an experienced installer to install the Extron NAV E 111 DTP3 streaming encoder and to make
all connections. The Extron NAV encoder and one or more compatible decoders form an AV distribution and switching matrix on a
managed 1G (1 Gbps) IP network.
NOTE:
For more information on any subject in this guide, see the NAV E 111 DTP3 User Guide, available at www.extron.com.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and rack or furniture mount the encoder as required.
Step 2 — Rear Panel Connections
1.0A MAX
100-240
50-60 Hz
E E E
Figure 1. NAV E 111 DTP3 Rear Panel Features
DTP3 input port — Plug a compatible Extron DTP signal into this RJ-45 port using a TP cable (see
A
on page 5 to wire the connectors).
ATTENTION:
• Via power over DTP, the encoder can remotely supply 48V power to a connected DTP3 transmitter or 12V power to a
legacy DTP transmitter. Selecting the incorrect power over DTP voltage for the connected transmitter can damage the
transmitter. See the NAV E 111 DTP3 User Guide, available at www.extron.com, to select the correct remote power
output.
• Via l'alimentation sur DTP, l'encodeur peut fournir une alimentation 48 V à distance à un émetteur DTP3 connecté ou
une alimentation 12 V à un émetteur DTP d'ancienne génération. La sélection d'une tension d'alimentation sur DTP
incorrecte pour l'émetteur connecté peut endommager ce dernier. Voir le NAV E 111 DTP3 User Guide, disponible sur
www.extron.fr, pour sélectionner la sortie d'alimentation à distance adaptée.
• Do not connect this port to a computer data or telecommunications network.
• Ne connectez pas ce port à un réseau de données informatiques ou de télécommunications.
HDMI Output port — Connect a display to this female HDMI connector for local loop-through monitoring of the source signal
B
(see LockIt Lacing Bracket
®
NAV 1G port — Connect to an Ethernet LAN on which one or more decoders also reside for streaming and control.
C
Reset button and LED — This button initiates three modes of reset (see the NAV E 111 DTP3 User Guide, available at
D
www.extron.com, for details).
Power connector — Plug the encoder into a grounded AC source.
E
for the complete user guide, installation instructions, and specifications
OUTPUT
SIG LINK
HDMI
DTP3 IN
A A A B B B
on page 5 to securely fasten the HDMI connector to the encoder).
NAV E 111 DTP3
LAN
RESET
NAV 1G
D D D C C C
NAV 1G PoE connector
1