Removing A 5-Ghz Radio Module - Cisco Aironet AIR-AP1200 Hardware Installation Manual

Chapter 8 5-GHz Radio Module Upgrade
Remove the 5-GHz access cover using the supplied Torx L-wrench (see
Step 3
Figure 8-1
1

Removing a 5-GHz Radio Module

To remove the 5-GHz radio module, follow these steps:
Remove all cables and power connections from the access point.
Step 1
Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 2
Unscrew the two mounting screws using the supplied Torx L-wrench
Step 3
Figure 8-2
1
2
Note
OL-4310-05
5-GHz Radio Access Cover
1 2 1
Access Cover Screws
5-GHz Radio Module
1 1 2
Mounting screws
5-GHz radio module antenna
Do not attempt to remove the mounting screws from the module; they are captured in the module
housing.
2
Access Cover
3
3 Access point
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Removing a 5-GHz Radio Module
Figure 8-1).
(Figure 8-2).
8-3